Data Sheet for Energy Efficient Construction

Date Customer Name Customer Phone # Job Site Address City Zip Avg. Ceiling Height

Builder Name . Builder Phone # . HVAC Dealer . Living Area Sq. Ft. . Home Orientation N S E W NE NW SE SW New Construction Addition

For the ultimate in comfort and low operational cost, Gulf Power recommends the construction of an EarthCents Home. See the other side of this form for details

Please circle or check the features to be installed.

1) Double Pane Windows: Vinyl Wood Metal Clear Low E: U-Value_______ SHGC________2) Gasket Weather-Stripped Exterior Doors: Metal Wood Fiberglass 3) Wall Insulation: R-19 R-4) Ceiling Insulation: Batts or Blown R-38 R-30

Blown Foam applied to the underside of the roof decking _________ R-Value _________ 5) Exterior Finish: Brick Stucco Vinyl Other _________ 6) Roof Color/Type: Dark or Light Shingle Metal Tile Avg. Roof Pitch ___________ 7) Slab: Off grade (R-19) ________8) Duct System: Conditioned Space Unconditioned Space 9) Lighting: ______% of Incandescent ______% of Fluorescent and/or CFL 10) Water Heating: Electric Yes No # of units ______ Gals./ea. ______ Where Located ______________ Water Heating Options: Heat recovery Unit* ______ Heat Pump Water Heater* ______ Solar Water Heater* ______

*Minimum 50 gallon hot water tank, hot water lines must be insulated

Heating & Cooling Information

The remainder of this form will be completed by Gulf Power and returned to you. Thank you. Notice: The following heat loss/heat gain calculation(s) is/are provided to assist the HVAC Contractor in properly sizing the heating and cooling equipment based on Northwest Florida Design Conditions (Summer: 95˚F Outdoor / 75˚F Indoor / 63˚F WB; Winter: 29˚F Outdoor / 70˚F Indoor) Do not size HVAC to meet ARI Design Conditions. HVAC Contractors should select equipment that, at a minimum, meets the sensible and latent load calculations below.

Air changes per hour:

Calculated Loads: 1st Floor / Zone 1 2nd Floor / Zone 2 3rd Floor / Zone 3

Heat Gain Sensible ______________BTUH _______________BTUH ______________BTUH Heat Gain Latent ______________BTUH _______________BTUH ______________BTUH

Total Cooling Load ______________BTUH _______________BTUH ______________BTUH

Total Heating Load ______________BTUH _______________BTUH ______________BTUH

Residential Energy Consultant Telephone # Date . Copy 1 /Builder or HVAC Dealer Copy 2 /Gulf Power

300670 (01/16)

EARTHCENTS HOME QUALIFICATIONS Single Family / Multi-Family / New / Existing

Minimum Required Features

OR

OR

**HVAC SIZING CRITERIA - Units must be sized according to the

latest editions of ACCA “Manual J”, ASHRAE Handbook of

Fundamentals, or an equivalent load calculation procedure; in

addition to the appropriate HVAC Equipment Manufacturers

Specifications. Equipment performance must be no less than

calculated cooling sensible and latent loads @ local design

conditions, and not more than 15% over calculated loads. In

specifying equipment, the next available size may be used. In addi-

tion, indoor and outdoor coils shall be matched in accordance

with ARI standards.

Minimum Required Performance Testing

≤

OR

OR

≤ ≤

OR

OR

OR

Additional Energy Efficiency Recommendations

Blown-in fiberglass Blown-in Cellulose

Blown-in expandable foam