Creative friendship bracelet pattern-how to

make a wavy friendship bracelet

With some strands of string, you can work actually creative friendship bracelet pattern along with the way you

knotting. It is an essentially easy-to-follow project for a wavy friendship bracelet from string.

Materials needed for wavy friendship bracelet:

1mm Nylon thread

6mm Abacus Glass Bead

Scissors

Lighter

How to work the wavy friendship bracelet?

Step1: string preparation

Decide the number of string you want to give your bracelet. In my project, I used 6 longer working

ends and 1 shorter holding end;

Step2: work the knots

1. Bundle up seven string strands at 7cm long from beginning ends with an overhand knot;

2. Pick out your holding end (Orange in my project), and spread rest 6 working ends on flat;

3. Nip working end in your right hand. Take the first working end, next loop it around your index

finger in clockwise;

4. Pass the working end through the loop;

5. Tighten the loop;

6. Do same processes for the rest 5 working ends in orders;

7. Turn the direction from right to left and keep working same processes.

For a friend, one piece of friendship bracelet is the

most personal testaments you can promise to other.

Celebrate your friendship while working out this truly

creative friendship bracelet pattern as the symbols of

love and care between you girls. There, in this project,

you will learn a stunning wavy friendship bracelet

from string. Here we go!

Voila, this is your wavy friendship bracelet! This creative friendship bracelet pattern may be

recommended among both novice and veteran. Hope that you have enjoyed it!

For step-by-step photos and instructions on the popular friendship bracelets, please head over to:

http://www.pandahall.com/learning-center/Friendship-Bracelets/grid-17-p1.html

Step3: conclude the wavy

friendship bracelet

In the end, make one extra loop with each

working ends to make the knots stay in place.

Step4: design a closure

1. Cut off the excess holding string at both

ends and fusion with lighter;

2. Reserve 7cm long tails for each ends, and

then cross with the leftover parts. Take

another string strip and work several Square

knots as closure;

3. Adorn one 6mm Abacus Glass Bead on

each end tail.