1

Cut some of organza Fabric into 3 inch strips

You are going to need 9 3x3 inch squaresRepeat this process with 2 inch and 1 and half inch Squares

Continue to cut fabric into squares you will needin total

9 3x3 inch squares2222 2x2 inch squares28 1.5x1.5 inch squares

Fold square in half, Fold again. Pinch tip of fabric where ends meets in center

Cut folded edges in a half circleopen to see circle. Do this to ALL the squares

Cut Felt into 5 1.5x1.5 squarescut these into circles as well, set aside

gather all 3 inch circlesfold one circle in half

apply bead of glue in center apply bead of glue in center fold in half (pinch together, looks like Petal)

place glue on back of “petal”Glue to one felt circle about 1/4 of an inch from

perimeter of felt circle

Glue all 9 petals onto felt, going in a circular motion, once done with perimeter

glue some in center to create full effectThis will create the flower

Do this to the 4 other felt pieces11 petals from the 2 inch circles

will be used on 2 of the remaining Felt circleswill be used on 2 of the remaining Felt circlesand 14 petals will be used from the

1.5 inch circles on the 2 other felt circles (5 flowers total) Fold ribbon in half to get center of ribbbon, place glue on it

Glue largest Flower onto center of ribbon, flip it onto its belly soflower is facing down, back is towards you

fold over edges (going up) at end of the flower, glue creases shut.now flip necklace over so flower is face up,

Glue on remaining flowers. Keeping close together

large in center,2 mediums on either side,then 2 small on either

side of that.

fold ribbon upcenter of ribbon

glue n circular motion

*Couture parties DIY Tutorials are Not to be resold for profit*

Open center of flower, add a dab of glue.insert rhinestone or button

(if you feel the flowers are too floppy, you can add glue to back of petals and secure to ribbon)

Fabulous