Upload
hadiep
View
213
Download
0
Embed Size (px)
Citation preview
Website: paracordgalaxy.com Email: [email protected] Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.
Cobra Weave Bracelet
Bring the cord up through the loop.
Melt the ends of two pieces of paracord and join together.
Make a loop near the joined ends and push through one side of a buckle
Pull tight leaving the joined ends near the buckle.
Bring the ends of the cord through the other side of the buckle.
Slide the second piece of the buckle toward the other end until you reach the length desired for your finished bracelet.
Website: paracordgalaxy.com Email: [email protected] Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.
This tutorial will start with the left patterned cord making it the center in the design. If you would rather have the solid cord in the
middle, start with the right solid cord. Bring the left cord over the center two cords and under the right cord as shown.
Bring the right cord under the center cords and up through the loop created on the
left.
Pull tight being careful not to move the buckle and adjust the length if needed.
Now reverse the steps and bring the right cord over the center two cords and under
the left cord.
Bring the left cord under the center two cords and through the loop on the right.
Website: paracordgalaxy.com Email: [email protected] Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.
Pull tight.
Trim and melt the ends to prevent fraying
Front Back
Continue alternating between the left and right cords until you reach the other end of
the bracelet.
This bracelet is about 8 inches and used about 4 feet in each color.