Canon AE-1 SLR Lens Mount ReplacementThis guide will demonstrate how to remove the SLR Lens Mount on the Canon AE-1.

Written By: Joe Blumberg

Canon AE-1 SLR Lens Mount Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

INTRODUCTION

This guide will teach the user how to remove a damaged SLR lens mount on the Cannon AE-1. TheSLR lens mount allows the user to connect different lens to the Canon AE-1.

TOOLS:Phillips #00 Screwdriver (1)

Canon AE-1 SLR Lens Mount Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5

Step 1 — SLR Lens Mount

Remove the first set of two #00 phillips screws from the lens outer casing

The first set of screws are located on the front and bottom of the lens casing

Pull the screws out and set them aside so as not to lose them

Canon AE-1 SLR Lens Mount Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5

Step 2

Remove the remaining two #00 phillip screws from the lens outer casing

The second set is located left and right side of the lens casing

Pull the screws out and set them aside so as not to lose them

Step 3

Once the screws have been takenout, you may simply remove the lenscasing by pulling it away from thebody of the camera.

Canon AE-1 SLR Lens Mount Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5

To reassemble your device, follow these instructions in reverse order.

This document was last generated on 2017-06-18 09:00:39 PM.

Step 4

Remove the four #00 phillips screwsfrom the SLR Lens Mount

Step 5

After the screws have been removed, pull the SLR Lens Mount away from the body of the camera

Be aware that a pin will fall out when the SLR Lens Mount is removed.

Canon AE-1 SLR Lens Mount Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5