12) Put grease on the thrust washer to hold it in position. Be sure the tang on the washer is in the slot in the block

(Fig.

[3] Install bearings of the correct size in the center bearing support, and install the support on the crankshaft. Be sure thenumbersonthesupportaretogether{Fig.

M}SlidethecrankshaftintotheFig.7B98zlnslailigrgstwasher7Fig.BearirTgSupp0CheckMarksblock.Usecarenottodamagethebearingintheblockduringinstallation.Besuretheholeinthebearingsupportisinalignmentwiththeholeinblock(Fig.

{5} Install the bearing of the correct size in the end plate. lnstali the thrust washer, seal and gasket. Be sure the hole inthebearingisinalignmentwiththeholeintheplate.Slidetheplateintoplaceandinstall20r3bolts(Fig.7B101l.

Fig.InstallingEndPlale

[61 Measure the end movement of the crankshaft (Fig. 7B102]. If it is not within the specification, install shim gasketsorthrustwashersasneeded,togetcorrectclearance.Usethesamesizethrustwasherson

bothsidesofcrankshaft,oruseonesizethickerontheblowerside.

I7]Tightenalltheboltsintheend.plateandtheboltinthebearingsupport.Turnthecrankshafttobesureitisfree.

Install the cylinder and rod assemblies, the oil pan, the cranksha gear and all other parts removed. Be sure the crankshaftgearfitsOnthepininthecrankshaft,andthetimingmarksareinaiignmentIFig.&7B104).

Theringgearforthestarterisremovedbycuttingitwithachisel(Fig.7B105).

Toinstallthenewgear,heatittoabout200c.,anditwillslideontothecoolflywheel.

700,720.721,722LoaderServiceManual