Upload
lythuy
View
238
Download
0
Embed Size (px)
Citation preview
Black and Decker PS1800 Switch ReplacementThis guide will show how to replace the Switch of Black and Decker PS1800.
Written By: Hamza Nawaz
Black and Decker PS1800 Switch Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5
INTRODUCTION
This guide will show how to replace the Switch of Black and Decker PS1800.
TOOLS:Phillips #00 Screwdriver (1)
Black and Decker PS1800 Switch Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5
Step 1 — Case
Flip device over so that the screw holes face up.
Use the Phillips #00 screwdriver to remove all six 18mm Phillips screws.
Use the Phillips #00 screwdriver to remove the single 12mm Philips screw.
Step 2
Remove one side of the Clamshell.
Black and Decker PS1800 Switch Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5
Step 3 — Switch
Remove all the screws securing the drill case to open.
The switch is highlighted in the middle of the drill.
Step 4
Pull out the switch.
Black and Decker PS1800 Switch Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-09-25 06:51:47 PM.
Step 5
Solder off all the joints.
Black and Decker PS1800 Switch Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5