Autodesk Inventor Keyboard Shortcuts Guide

  • Published on
    31-Dec-2016

  • View
    218

  • Download
    0

Transcript

  • Shortcut Key Guide

  • 2

    TABLE OF CONTENTS

    One Key Shortcuts

    Keyboard Diagram ..................................................................... 3

    Printable Keyboard Stickers ........................................................ 14

    Keyboard Shortcut Commands by Category

    Assembly ................................................................................... 4

    Drawing Manager ...................................................................... 4

    General ...................................................................................... 4

    Part ............................................................................................ 4

    Placed Features .......................................................................... 4

    Sketch ....................................................................................... 5

    Tools .......................................................................................... 5

    View .......................................................................................... 5

    Work Features ........................................................................... 5

    Multi-Character Command Aliases by Category

    Annotation ................................................................................ 6

    Assembly ................................................................................... 6

    Cable & Harness ........................................................................ 6-7

    Dimension ................................................................................. 7

    Drawing Manager ...................................................................... 8

    Dynamic Simulation ................................................................... 8

    Frame Analysis ........................................................................... 8-9

    Mold Design .............................................................................. 9-10

    Part ............................................................................................ 10

    Placed Features .......................................................................... 11

    Presentation ............................................................................... 11

    Sheet Metal ............................................................................... 11

    Sketch ....................................................................................... 11-12

    Sketch Features .......................................................................... 12

    Stress Analysis ............................................................................ 12-13

    Tools .......................................................................................... 13

    Tube & Pipe ............................................................................... 13

    View .......................................................................................... 13

    NOTE: To enable the use of multi-character command aliases in Inventor, make sure the Use default multi-character Command Aliases option is checked. To access this, select Tools tabOptions panelCustomize, and click the Keyboard tab.

  • 3

    ONE KEY SHORTCUTS [SEE PRINTABLE KEYBOARD STICKERS ON PAGE 14]

    F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12

    ACaps Lock Enter

    Backspace

    PrtScnSysRq

    Home End

    Insert PageUp

    Delete PageDown

    PauseBreak

    ScrLK

    Shift Shift

    Esc

    Tab

    Ctrl Start Alt Alt Ctrl

    S D F G H J K L

    Z X C V B N M

    Q

    1! @ # $ % ^ & * ( )

    -~`

Recommended

View more >