Action CameraUSER MANUAL

PLEASE READ AND UNDERSTAND THIS MANUAL COMPLETELY BEFORE USE.

1Adventure Kings Action Camera

Precautions

• Do not clean the camera with chemicals or solvents such as cleaning solutions or detergents.

• Do not expose the camera to magnetic fields, such as electrical motors or magnets.

• Do not expose the camera to high or low temperatures. The normal operating temperature of the camera is 0ºC to 40ºC (32F to 104F).High temperatures can shorten the lifespan of electronic devices and extremely high/low temperatures will shorten the battery life and/or degrade the plastic components

• Overcharging the battery can damage the battery and shorten the battery life.

• Before you start recording with the camera, format the memory card in the settings menu or on a computer to avoid potential camera or card malfunctions. Memory cards should be formatted regularly to avoid potential camera or card malfunctions.

• If dust or dirt is on the camera or on its lens, use a soft, clean and dry cloth to wipe away debris gently.

• Take care and prevent water or sand particles from entering the housing. Water, sand particles and dust containing salt may cause damage.

• Do not use a cloth to wipe sand particles. Gently blow them away then wipe the camera with a soft cloth.

2Adventure Kings Action Camera

Overview

(1) Power/Mode Button (2) Lens (3) Indicator Light

(4) OK-Button (5) Micro SD Slot (6) Micro USB Port

(7) Micro HDMI Port (8) Screen (9) Charging Light

(10) Up Button (11) Down Button (12) Speaker

3Adventure Kings Action Camera

Charging The Battery

Connect the supplied micro USB cable into the camera’s micro USB port into a wall adaptor, car charger or computer USB 2.0 port. The camera will turn on, the Charging Light will emit a blue light while charging and will turn off when charging is complete.

Note: the Indicator Light will remain on if the Action Camera is on. When plugged into a power source that isn't a computer, the camera will automatically start recording.

Installing And RemovingThe Micro SD Card

1. Make sure the camera is off when inserting or removing the micro SD card.

2. Insert the memory card in the correct direction (the gold contacts on the SD card should face the front of the camera) into the Micro SD card slot. Damaged or lost data may occur if installed incorrectly.

3. To remove the micro SD card, using your fingernail, press down on the card until it clicks. It will now pop up out of the camera.

Turning The Camera ON/OFFTURNING ON THE CAMERA• Press the Power/Mode button, after 4 seconds the Screen

will display the start-up screen and a sound is heard. The Indicator Light will show red.

TURNING OFF THE CAMERA• Press and hold the Power/Mode button for 4 Seconds

until the Screen displays the Adventure Kings Logo and a sound is heard. The screen will go blank and the Indicator Light will turn off.

• After 3 minutes (default) of inactivity, the camera will shut down automatically, conserving battery life.

Indicator Light

Micro SDCard Slot

Power/Mode Button

4Adventure Kings Action Camera

Capture/Playback ModesOnce the camera is switched on, the default capture mode is video. To change the mode, press the Power/Mode button to cycle through the modes.

They will display in the following order:VIDEO | LOOP RECORD | PHOTO | PLAYBACK

Mode Description

Video Record video

Loop Record Record videos continuously for a pre-set duration

Photo Capture photo

Playback Video, Loop Record and Photo Playback

Settings Mode and camera settings

To access the setting menu, first be in Video, Loop Record or Photo Mode and then press the Down button on the side of the camera. This will bring up the corresponding modes settings and the camera settings.(Press the OK-button when no mode settings are highlighted)

5Adventure Kings Action Camera

Video Mode

TO START RECORDING1. Once the camera is switched on it will default to the video recording screen.2. Press the OK-button to start the recording, the Indicator Light will illuminate, flashing on

and off and will emit a short beep to indicate the camera is recording.

TO STOP RECORDING 1. Press the OK-button again to stop the recording, there will be a short beep and the Indicator

Light will stop flashing. Note: When the battery is drained, the recording will cease automatically, and the camera will switch off.

Loop RecordThis cyclic record feature is usually used when the camera records something endlessly for a long period of time. It will record videos continuously for a pre-set duration (1, 3 & 5 Minutes) overwriting the oldest data on the memory card. 1. To start loop recording select the Loop Record Mode on the camera, Press the Power/Mode

button until selected. 2. Press the OK-button to start recording, A short beep and the Indicator Light will start to

flash red, indicating the camera is recording. 3. To stop recording, press the OK-button again. A short beep will sound, and the Indicator

Light will stop flashing. Note: When the storage is full, the camera will delete the oldest video clip and start another clip.

Photo Mode• Select the photo mode by pressing the Power/Mode button until the correct mode is

selected. • Press the OK-button. The camera will produce a short beep and a shutter sound.

Playback ModeTo view your videos and photos make sure the camera is in the Playback mode by pressing the Power/Mode button repeatedly until mode correctly selected. • Choose between Video, Loop Rec or Photo by pressing the Up or Down buttons on the side

of the camera. Use the OK-button to select which media you would like to view. • Use the Up and Down buttons to scroll through the videos or photos. Press the OK-button

to review a video. • To return, press the Power/Mode button.

6Adventure Kings Action Camera

Camera Settings

Depending on which media mode your camera is currently in will depend on which settings will be selected. e.g. if you are in the Video Mode and select settings, the video settings will pop up. Whereas if you were in the Photo Mode and selected settings the photo settings will appear.

• To select the settings menu, once in a capture mode screen, press the Down button to enter the Setting menu.

• Press the OK-button to swap between the mode settings and the camera settings.

• To scroll through the sub-menu options, press the Up and Down buttons.

• To select/change one of the sub-menu setting options, press the OK-button.

• Once the menu option has been changed you will return to the main setting menu.

• To go back or exit the Settings menu, press the Power/Mode button.

Setting Description Options Default

Video/Loop Rec Settings

Resolution Set the video resolution to your preferred output 1080P (30fps)/720P (60fps)/720P (30fps) 1080P (30fps)

Video Quality Choose the video quality Super Fine/Fine/Normal Super Fine

Loop Interval Choose the loop recording timeAvailable from the Loop Record Mode

1min/3mins/5mins1min

White Balance Set to adjust colour Auto/Daylight/Cloudy/Tungsten/Fluorescent Auto

Slow Motion Turn slow motion ON/OFF OFF/ON OFF

Date Stamp Set the date & time format OFF/Date/Date & Time Date & Time

Photo Settings

Resolution Set the photo resolution to your preferred output 12M/10M/8M/5M/3M/2M/1.3M 12M

Quality Choose the photo quality Super Fine/Fine/Normal Super Fine

White Balance Set to adjust colour Auto/Daylight/Cloudy/Tungsten/Fluorescent Auto

Self-Timer Turn self-timer ON/OFF OFF/2 secs/10 secs OFF

Photo Burst Turn the photo burst function ON/OFF OFF/3/5/10 OFF

Date Stamp Set the date & time format OFF/Date/Date & Time OFF

Camera Settings

Sounds

BeepVolumeVoice Rec

Turn the sound ON/OFF Press and hold OK-button to scroll through options

ON/OFF1/2/3/0ON/OFF

ON1ON

Power Save Turn ON/OFF automatic shut down OFF/1 min/3 mins/5 mins 3 mins

Screen Saver Turn On/OFF inactivity screen OFF/1 min/3 mins/5 mins 1 min

Screen Rotation Change the image orientation on the screen OFF/ON OFF

Date & Time Set the date & time formatPress and hold OK-button to move across

YY/MM/DD 00:00YY/MM/DD

00:00

Language Set the language EN/SC/TC/FR/NL/ES/IT/PT/DE/PL/RU/JP/KR/TH EN

Frequency Set the power frequency 50HZ/60HZ 50HZ

SystemCamera information & reset the camera to the

factory resetFactory Reset/System Info/Card Info

Format Format the micro SD card Yes/No

7Adventure Kings Action Camera

Transferring Files To A Computer

1. Turn the camera ON and connect to a PC or MAC’s USB 2.0 port via the supplied micro USB cable. The camera screen will display a connecting screen.

2. Your captured videos and images will be accessible from your computer. Note: Alternatively, you can remove the Micro SD Card from the camera and insert the card into a card reader.

Included Accessories

Waterproof Housing Waterproof Housing Mount

Mount Adapter (x2)

Curved Mount Adhesive Clip Base (x2) Micro USB Cable

1. To fit and test Waterproof Housing:

2. Release the secure clasp of the Waterproof Housing

3. Inspect the rubberised seal to be sure it’s in good condition.

4. Test the integrity of the seal by closing the waterproof housing without inserting the camera. Submerse the waterproof housing completely in water for about a minute.

5. Remove the housing from the water, dry and then open.

6. If the whole interior is dry, the housing is safe for underwater use.

Due to possible user resealing error, this product is not covered under warranty against Waterproof Housing leakage or any resulting damage. Please review and follow the instructions carefully when sealing the Waterproof Housing.

Waterproof Housing

8Adventure Kings Action Camera

WARRANTY PERIOD:

Full 12 month warranty from date of purchase against all manufacturing defects.

WHAT DOES THE WARRANTY COVER?

Under normal usage conditions, this warranty covers:

a. Any defect in design or manufacture which results in the product failing to perform substantially as described in authorised advertising or literature.

b. We will either repair or replace the product at our discretion providing that the fault is found to have been caused by a design or manufacturing defect and not misuse or tampering.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits provided to you as the consumer by this warranty are in addition to other rights and remedies available to you under the law.

THE WARRANTY DOES NOT COVER:

a. Any damage resulting from improper use

b. Faulty installation or modification made during installation

c. The cost of removing and reinstalling the product

d. Travel and /or other expenses due to customer’s remote location

e. Transport charges and damage in transit. It is your responsibility to deliver and pick up your product, including any costs associated with the postage of your repair or replacement product. If you do freight your product we recommend that you insure against loss or damage.

f. Any loss directly or indirectly associated with the product failing to operate.

g. Damage caused by mould, insects, animals, misuse, incorrect operation, adverse weather, accidents

and fair wear and tear

TO MAKE A CLAIM UNDER THIS WARRANTY PLEASE CALL

1800 88 39 64

12 MONTH LIMITED

WARRANTY

OUTDOOR SUPACENTRE PTY LTD2 Stanley St Silverwater NSW, 2128PHONE: 1800 88 39 64www.4wdsupacentre.com.au

9Adventure Kings Action Camera