1
A NEW SILICON PHOTOVOLTAIC PYRANOMETER FOR MEASURING SOLAR IRRADIANCE IN METEOROLOGICAL AND SOLAR RESOURCE APPLICATIONS T. Thomas * , D. Johnson, D. Heinicke, R. Peterson, P. Morgan, J. Wurm, D. McDermitt, G. Burba, and B. Biggs LI-COR Biosciences, Lincoln, NE, USA. * [email protected] INTRODUCTION REFERENCE LI-200 PYRANOMETER REFERENCES NEW LI-200R PYRANOMETER PERFORMANCE OF NEW vs OLD DESIGNS: LATEST RESULTS LI-COR solar radiation measurements: Designing solar radiation sensors for over 40 years Sensors used at thousands of locations around the world Used for solar resource assessment, photovoltaic efficiency monitoring, meteorological and agricultural studies Silicon photovoltaic design advantages of LI-200 Pyranometer: Low-maintenance, proven field performance [2, 3] Lower cost than thermopile designs Lower sensitivity to dust and dirt compared to thermopile designs Response time less than 1μS (2m cable terminated into 147 Ω load) In unobstructed daylight conditions, LI-200 Pyranometer compares well with thermopile pyranometers [1, 2, 3] LI-200: silicon photovoltaic detector, fully cosine-corrected miniature head, current output directly proportional to solar radiation New Design Azimuth Response Cosine response is corrected well up to 82° angle of incidence* Detachable sensor head Easy removal for calibration w/o unwiring Larger drain for improved water shedding High-speed, fully cosine corrected Designed for continuous monitoring μA and mV (with adapter) output Sensitivity typically 90μA per 1000 Wm -2 Errors were below 1% in new LI-200R over 360° at 45°elevation New Design Cosine Response [1] Biggs, William W. (1984). Principles of Radiation Measurement. LI-COR, Inc. Lincoln, NE [2] Kerr, J. P., Thurtell, G. W., & Tanner, C. B. (1967). An integrating pyranometer for climatological observer stations and mesoscale networks. Journal of Applied Meteorology, 6(4), 688-694. [3] Weiss, A., & Norman, J. M. (1985). Partitioning solar radiation into direct and diffuse, visible and near-infrared components. Agricultural and Forest meteorology, 34(2), 205-213. In 1:1 comparison, new LI-200R performed well vs reference LI-200 at 1 minute intervals with no averaging Irradiance from new LI-200R and reference LI-200 sensors. Values represent an average of 5 pyranometers. New Design Output vs. Reference Irradiance Response Daily Irradiance Photo: Aaron Deschane The LI-200SA Pyranometer spectral response along with the energy distribution in the solar spectrum. [1, 2] The sensitivity of new LI-200R sensors as a function of angle of incidence Azimuth errors for a set of 5 new LI-200R sensors at 45˚ angle of incidence Under unobstructed daylight conditions, new LI-200R pyranometer compared well with reference LI-200 *A sensor without an accurate cosine correction can give a severe error at low solar elevation angles. The cosine error at angle 0 is the percent difference of the ratio of the measured output at angle 0 and normal incidence (angle 0°) as compared to the cosine of angle 0 New LI-200R performed well vs reference LI- 200 (data for 1 minute intervals with no averaging) LI-COR is a registered trademark of LI-COR, Inc. All other trademarks belong to their respective owners. This poster contains no confidential information. Open base with head removed Closed base with head removed Overall view y = 0.0789x + 0.0628 R² = 0.9999 0 10 20 30 40 50 60 a Current (μA) output from new LI-200R sensors as function of reference LI-200 irradiance (Wm -2 ) Irradiance from new LI-200R sensors plotted against irradiance values from reference LI-200 sensors 0 100 200 300 400 500 600 700 800 AM 7:37:00 AM 11:37:00 PM 3:37:00 Reference Irradiance New Irradiance Time Example of one day 20° 40° 60° 80° 100° 120° 140° 160° 180° 200° 220° 240° 260° 280° 300° 320° 340° A B C D E +1% error -1% error +5% +4% +3% +2% -2% -3% -4% -5% +1% -1% Reference Sensor: Irradiance (Wm -2 ) y = 0.0774x - 0.0097 R² = 0.9998 = y = 0.0742x - 0.0013 R² = 0.9999 0 10 20 30 40 50 60 0 500 1000 c y = 0.079x + 0.0086 R² = 0.9998 0 500 1000 = 0 100 200 300 400 500 600 700 0 100 200 300 400 500 600 700 New Sensor: Irradiance (Wm -2 ) Reference Irradiance (Wm -2 ) y = 0.997x - 0.089 R² = 0.999 3615 data points per each of 5 sensors Detachable head Detachable base Leveling plate

A NEW SILICON PHOTOVOLTAIC PYRANOMETER FOR …LI-COR solar radiation measurements: • Designing solar radiation sensors for over 40 years • Sensors used at thousands of locations

  • Upload
    others

  • View
    12

  • Download
    0

Embed Size (px)

Citation preview

Page 1: A NEW SILICON PHOTOVOLTAIC PYRANOMETER FOR …LI-COR solar radiation measurements: • Designing solar radiation sensors for over 40 years • Sensors used at thousands of locations

A NEW SILICON PHOTOVOLTAIC PYRANOMETER FOR MEASURING SOLAR IRRADIANCE IN METEOROLOGICAL AND SOLAR RESOURCE APPLICATIONS

T. Thomas*, D. Johnson, D. Heinicke, R. Peterson, P. Morgan, J. Wurm, D. McDermitt, G. Burba, and B. Biggs LI-COR Biosciences, Lincoln, NE, USA. *[email protected]

INTRODUCTION REFERENCE LI-200 PYRANOMETER

REFERENCES

NEW LI-200R PYRANOMETER

PERFORMANCE OF NEW vs OLD DESIGNS: LATEST RESULTS

LI-COR solar radiation measurements:

• Designing solar radiation sensors for over 40 years

• Sensors used at thousands of locations around the world

• Used for solar resource assessment, photovoltaic efficiency

monitoring, meteorological and agricultural studies

Silicon photovoltaic design advantages of LI-200 Pyranometer:

• Low-maintenance, proven field performance [2, 3]

• Lower cost than thermopile designs

• Lower sensitivity to dust and dirt compared to thermopile designs

• Response time less than 1μS (2m cable terminated into 147 Ω load)

In unobstructed daylight conditions, LI-200 Pyranometer compares well

with thermopile pyranometers [1, 2, 3]

LI-200: silicon photovoltaic detector, fully cosine-corrected miniature

head, current output directly proportional to solar radiation

New Design Azimuth Response

Cosine response is corrected well up to 82° angle of incidence*

Detachable sensor head

Easy removal for calibration w/o unwiring

Larger drain for improved water shedding

High-speed, fully cosine corrected

Designed for continuous monitoring

μA and mV (with adapter) output

Sensitivity typically 90μA per 1000 Wm-2

Errors were below 1% in new LI-200R over 360° at 45°elevation

New Design Cosine Response

[1] Biggs, William W. (1984). Principles of Radiation Measurement. LI-COR, Inc. Lincoln, NE [2] Kerr, J. P., Thurtell, G. W., & Tanner, C. B. (1967). An integrating pyranometer for climatological observer stations and mesoscale networks. Journal of Applied Meteorology, 6(4), 688-694. [3] Weiss, A., & Norman, J. M. (1985). Partitioning solar radiation into direct and diffuse, visible and near-infrared components. Agricultural and Forest meteorology, 34(2), 205-213.

In 1:1 comparison, new LI-200R performed well vs reference LI-200 at 1 minute intervals with no averaging

Irradiance from new LI-200R and reference LI-200 sensors. Values represent an average of 5 pyranometers.

New Design Output vs. Reference Irradiance Response Daily Irradiance

Photo: Aaron Deschane

The LI-200SA Pyranometer spectral response along with the energy distribution in the solar spectrum. [1, 2]

The sensitivity of new LI-200R sensors as a function of angle of incidence

Azimuth errors for a set of 5 new LI-200R sensors at 45˚ angle of incidence

Under unobstructed daylight conditions, new LI-200R pyranometer compared well with reference LI-200 *A sensor without an accurate cosine correction can give a severe error at low solar elevation angles. The cosine error at angle 0 is the

percent difference of the ratio of the measured output at angle 0 and normal incidence (angle 0°) as compared to the cosine of angle 0

New LI-200R performed well vs reference LI-200 (data for 1 minute intervals with no averaging)

LI-COR is a registered trademark of LI-COR, Inc.

All other trademarks belong to their respective owners.

This poster contains no confidential information.

Open base with head removed

Closed base with head removed

Overall view

y = 0.0789x + 0.0628 R² = 0.9999

0

10

20

30

40

50

60a

Current (μA) output from new LI-200R sensors as function of reference LI-200 irradiance (Wm-2)

Irradiance from new LI-200R sensors plotted against irradiance values from reference LI-200 sensors

0

100

200

300

400

500

600

700

800

AM7:37:00

AM11:37:00

PM3:37:00

Reference Irradiance

New Irradiance

Time

Example of one day 0°

20°

40°

60°

80°

100°

120°

140°

160°180°

200°

220°

240°

260°

280°

300°

320°

340°

A B C D E

+1% error

-1% error

+5%

+4%

+3%

+2%

-2%

-3%

-4%

-5%

+1%

-1%

Reference Sensor: Irradiance (Wm-2)

y = 0.0774x - 0.0097 R² = 0.9998 =

y = 0.0742x - 0.0013 R² = 0.9999

0

10

20

30

40

50

60

0 500 1000

c y = 0.079x + 0.0086

R² = 0.9998

0 500 1000

=

0

100

200

300

400

500

600

700

0 100 200 300 400 500 600 700

New

Se

nso

r: Ir

rad

ian

ce (

Wm

-2)

Reference Irradiance (Wm-2)

y = 0.997x - 0.089 R² = 0.999

3615 data points per each of 5 sensors

Detachable head

Detachable base

Leveling plate