i913-611 www.powercommander.com 2000-2004 BMW F650 - PCIII USB - 1

2000-2004 BMW F650 GS/DakarInstallation Instructions

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Alcohol Swab1 O2 Sensor5 Zip ties

You can also download the PowerCommander software and latest mapsfrom our web site at:

www.powercommander.com

The ignition MUST be turnedOFF before installation!

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

Optional Gauge

6 Locate the Throttle Position Sensor onthe right hand side of the throttlebody.

Unplug the stock wiring harness fromthe TPS.

7 Plug the 4 pin connectors from thePCIII in-line of the TPS and stockwiring harness (Fig. C).

i913-611 www.powercommander.com 2000-2004 BMW F650 - PCIII USB - 2

5 Plug the matching connectors fromthe PCIII in-line of the throttle bodyand wiring harness (Fig. B).

Align the PCIII connector to the stockwiring harness as shown below. Thesquare edges of the PCIII connectoralign with the spring clip side of thestock wiring harness

1 Remove the seat.

2 Remove the right hand upper fairingand the center piece over the air box.

3 Lay the PCIII in the tail section tem-porarily.

4 Unplug the stock wiring harness fromthe throttle body (Fig. A). This con-nection is located to the rear of the airbox next to the frame crossover.

Fig.

AFi

g. B

Fig.

C

Stock connector

Connectionlocated inthis area

PCIII connector

PCIII connector

Stock connector

PCIIIsquare edges

StockSpring clip

10 Plug the connector from the DynojetO2 sensor into the PCIII harness (Fig.E).

11 Plug the round connector from thePCIII harness into the stock wiringharness where the stock O2 sensorwas unplugged from (Fig. E).

12 Zip tie the PCIII harness to the frameas shown in Fig. F.

Fig.

EFi

g. F

i913-611 www.powercommander.com 2000-2004 BMW F650 - PCIII USB - 3

8 Remove the stock O2 sensor from theexhaust (Fig. D) This is accessiblefrom the left side of the bike. Unplugthe stock sensor from the wiring har-ness

9 Install the supplied Dynojet wideband sensor into the exhaust.

Fig.

D

To O2 sensor

To PCIII

O2 sensor harness

O2 sensor

13 Mount the PCIII to the inner rearfender using the supplied velcro.Make sure to clean both surfacesbefore attaching.

Fig.

G

i913-611 www.powercommander.com 2000-2004 BMW F650 - PCIII USB - 4