www.klinger.co.at

KLINGER®soft-chemKLINGER®soft-chem brings the sealing technology on a new level and it is the best choice for operating condi-tions up to 260°C.

Multi-directional expanded PTFEExcellent corrosion resistance together with superior sealability create a high-grade gasket material for a wide field of applications in your plant.

» Multi-directional expanded PTFE » Suitable for a wide range of applications

» Conforms to the regulation (EU) No. 1935/2004 (incl. 10/2011)

» FDA conformity (components of KLINGER®softchem comply with the FDA requirements)

Key features:

» Easy to cut » Excellent sealing at low stress » Seals irregular flanges » No ageing of the material

Benefits:

Properties:

Industries:

SUPERIOR

EXCELLENT

VERY GOOD

GOOD

MODERATE

MECHANICALRESISTANCE

THERMALRESISTANCE

SEALABILITY CHEMICALRESISTANCE

Certificates and approvals:

TRANSPORTPULP & PAPEROIL & GASCHEMICAL INFRASTRUCTUREENERGYINDUSTRY FOOD & BEVERAGES

PHARMA

referring to KLINGER® top-chem product range

www.klinger.co.at

Compressibility ASTM F 36 M % 50-60

Recovery ASTM F 36 M % 13-17

Stress relaxation DIN 52913 30 MPa, 16 h/150°C MPa 15

KLINGER cold/hot compression thickness decrease at 23°C % 35

25 MPa thickness decrease at 150°C % 30

Tightness DIN 28090-2 mg/s x m 0.001

Density g/cm3 0.9

pT diagram for thickness 2.0 mm:

Typical technical data for thickness 2.0 mm:

Certified acc. to DIN EN ISO 9001:2008 Subject to technical alterations. Status: March 2016

Rich. Klinger Dichtungstechnik GmbH & Co KG » Am Kanal 8-10 » A-2352 Gumpoldskirchen, AustriaTel +43 (0) 2252/62599-137 » Fax +43 (0) 2252/62599-296 » e-mail: marketing@klinger.co.at

1500 x 1500 mm

1.5 mm, 2.0 mm, 3.0 mm

Thicknesses:

Thickness 10%Length 50 mm, width 50 mm

Other thicknesses, sizes and tolerances on request.

Tolerances:

Dimensions of the standard sheets:

Sizes:

2 31

In area one, the gasket material is normally sui-table subject to chemical compatibility.

In area two, the gasket material may be suitable but a technical evaluation is recommended.

In area three, do not in-stall the gasket without a technical evaluation.

Always refer to the che-mical resistance of the gasket to the media.

-2000

20

30

40

50

60

70

80

90

100

0°C 100 200 300 400-100

pibar

3

21

-2000

20

30

40

50

60

70

80

90

100

0°C 100 200 300 400-100

pibar

3

21

-2000

20

30

40

50

60

70

80

90

100

0°C 100 200 300 400-100

pibar

3

21

1

1