Embed Size (px)
Citation preview
………………………………………………………….. TECHNICAL
Maintenance
C&I Engineers, C&I Supervisors & C&I
Technicians
Technical Department
Engineers, Supervisors
Project & Commissioning Dept
Engineers, Supervisors
Operation Dept
Process Engineers, Supervisors
Most organizations focus more on …. This course is designed to explain the following:
The course is designed to enable technicians to confidently calibrate the controls and diagnose Problems in speedtronic Mark V control system.
The course is designed to provide a solid background in turbine governing systems.
Participants increase their skills in relating machine operating requirements to the speedtronic control.
And more…
Protection and Controls Descriptions - Start‐up and Shutdown Sequences
- Control Functions, Turbines Protection
- Water Wash, Combustion Monitor
- DLN Compatibility ( Dry Low NOx )
- Gas Control Value Reference Calculation (SRV/GCV)
Servo Valve Drive System - Servo Valve,Regulator,LVDT and NullBias
Calculation.
Mark V Architecture Definition of the variables - IN/OUT : IO.ASG
- Alarm: ALLOCSSP.ASG
- Internal: FACTORY .ASG/ SITE.ASG
Initialization - CONST_Q.SRC, IO_CFG.AP1, SEQ _XXXX.SRC
Compilation & Download - MK5MAKE, EEPROM DOWNLOAD
Mark V Studio Mark V Procedures - Overspeed test ( Electronic, Electrical and
overspeed bolt)
- SRV, GCV, IGV and Nozzles Calibrations
- Add new signal on Trip Log display, add new alarm.
Display Application - ARCWHO, CHECKCRC
Troubleshooting
And more...
Venue
OGEC Training Centre Sfax ‐ Tunisia
Course Dates
Book a Course
Course Duration
05 Days
SPEEDTRONIC TM Mark V Control System
COURSE OUTLINE CONCERNED POPULATION
WHY YOU SHOULD ATTEND ?
Ref : OT-TEC07
Tel: + 216 74 221 550 Fax: +216 74 210 718 E‐mail :[email protected]
Training Program – 2013/2014
Refer to: OGEC‐Training Calendar 2013/2014
