Quasar Wire Manual Wire Binder

Welcome to MyBinding presentation. This is a demonstration of the Quasar Wire, a manual wire binder by Fellowes

Simple, sleek, and compact, the Quasar Wire by Fellowes is a great wire binder. Let's watch it step-by-step in action.

Lift the punch handle and the lid to go from stowaway to operational. Begin with the covers. Let's put the left side,

the bind side, into the throat of the machine.

Adjust the side margin control knob to the size paper you're using so that all punches will be consistent throughout your

project and punch down.

If you're satisfied with the results, continue on punching through the rest of the papers in your project. And now it's

time for the binding.

Assemble your project in order and select the right size wire bind for your book.

Now, place the wire loops over the fence in the back. This holds it in place while you thread your project onto it.

A little trick in wire binding is to take the back cover and flip it around so that it faces the front cover.

This way the seam in the end will be hidden between the back cover and the back pages. Now that your book is in its new

order,

go ahead and thread it over the teeth of the wire bind, right through every hole.

The Quasar Wire has a built-in wire closer. Twist the spine around so that the "C" faces down into the wire closer.

Use the lever to close the closer and press the fence just as far as you need.

There's a guide built-in that comes out as you close

Remove your project and you're done. And that's it.

That's the Quasar Wire binding system by Fellowes

For more demonstrations and reviews of this product and many more, check out MyBinding.com.